Methodology Sample Questions

1. When designing a motion control axis, the first consideration should be the

1. load requirements
2. electronic hardware
3. software language
4. system mechanical operation
5. nature of the feedback

2. Top / down design is a technique to...

1. design systems in general
2. design the software side of systems
3. design the hardware side of systems
4. tune motors
5. write user manuals

3. Assuming identical performance potential, the selection of a motion technology should be made based on

1. life cost
2. initial investment
3. efficiency
4. maintenance
5. return on investment

4. What is the first step in solving an automation application?

1. Define the application objectives
2. Attend a seminar on the technology
3. Select the vendor(s)
4. Hire a consultant
5. Make the stepper vs. servo motor decision

5. System Documentation should include all of the following except...

1. subsystem schematics without system modification noted.
2. individual components schematics
3. maintenance procedures.
4. system logbook.
5. setup and tuning manuals.

Page Revised: July 14, 2003